1. Play a mission and switch off power to a room.
2. When the mission ends, click to retry the mission.
3. Click on the room that was switched off on the previous attempt of the mission.
4. Observe that the power and cooling statistics are showing as 0.
5. Switch the module off and on.
6. Observe that the correct power and cooling statistics are now shown.
Note: This only affects the readings and does not affect the actual power supply.
EDIT: I started a new ship design. I have yet to place any power plants. Note that power grids 1 and 2 are showing old values:
Attachment:
PowerGridValuesNotUpdating.jpg [ 102.39 KiB | Viewed 3289 times ]